Do I need to scan the exterior of the property?
What's optional, and how to capture it properly if you do.
Exterior scanning is optional, but anything you don't scan (like a porch, deck, or patio) won't show up on your floor plan. For outdoor spaces, we draw carports, patios, balconies, decks, porches and swimming pools. Gardens, yards, driveways and parking pads aren't included, and we don't offer site plans at this time. An exterior scan is a nice addition, but it doesn't replace scanning the inside: for upper floors in particular, your interior scan gives us the most accurate measurements.
If you're including the outside, walk the perimeter at a steady distance, capture from foundation to roofline, and — this is the most important part — finish where you started, with a bit of overlap.
If you begin at a corner, walk a little past it before finishing. Detached structures like a garage get their own separate scan within the same project.
For exterior scans specifically, aim to stay 5–15 feet from the wall — close enough to capture detail, far enough to see a useful width of wall at once. When you reach a corner, keep walking as you round it rather than stopping to swing the phone — angle the camera slightly across the corner so both wall faces land in the same frame. Avoid stepping sideways along a wall while facing it, since that's what causes tracking to lose track.
For anything higher up — a dormer, a second-story window, the roofline — tilt up and capture it from two or three different spots along the wall rather than just once. This gives the model multiple angles to reconstruct the shape accurately.
For a porch, deck, or patio: walk across it first to get full coverage of the wall behind it, then loop around the structure itself before continuing your route.
If a fence or other obstacle blocks part of the perimeter, start right at the obstacle and walk the loop all the way around to its far side — that way the only gap in your coverage is the obstacle itself. Where it's safe to do so, you can reach the phone out over a low fence or barrier to capture a bit of coverage on the other side, but skip this if the reach feels risky. Even without reaching over, try to capture the same feature (a window, vent, or roofline) from both sides of the fence — seeing it from both angles helps the model line the two halves up correctly.
Also worth knowing: it's best to stick to one orientation for the whole scan — if you want landscape photos, start in landscape from the beginning rather than switching partway through.
Related articles
I couldn't get all the way around the property — is a partial exterior scan still useful?
What to do if you can't get all the way around your property during an exterior scan
My preview looks misaligned when I get back to my starting point — did I mess up?
Why this usually isn't a problem, and what to do.
How should I prepare before I start scanning?
Three quick checks before you begin, plus how to get the home ready.
Still need help?
- General questions
- hello@inform.re
- Customer service
- help@inform.re